ВниманиеСоблюдайте меры предосторожности
Рекомендуемое оборудование
[1] gas burner
[2] gas burner adapter
[3] adapter on tank
[4] station for repressurising suspension spheres 4130-T
[5] пистолет
Снятие
ВниманиеВывести автомобиль из помещения сервисной станции
Снять
- The tank cover
- Крышку (1)
Отсоединить электромагнитный клапан (2) (positive terminal)
Connect the LPG tank to earth, в "a"
ВниманиеЗапустить двигатель. Перейти на работу в режиме агазб. дождаться остановки двигателя после полной выработки сжиженного газа (gpl). выключить зажигание. отсоединить аккумуляторную батарею (positive terminal)
Disconnect the tube (4) from the union (5)
Connect the gas burner [1] to the tank outlet using the connector tube (3) and adapters [2] and [3]
Keep the valve (6) in the "off" position
ВниманиеPosition the gas burner [1] 20 m from any inflammable substances and as far away as possible from the vehicle
Connect the gas burner [1] to earth, в "b"
Open the valve (6) slightly
Connect the positive terminal of the electrovalve (2) to the positive terminal of the battery with a fly lead
Bleed the gas burner [1] by opening the valve (10) slightly until tube (9) ices up then close the valve (10)
Bleed the pilot tube by opening the valve (7) by 1/4 of a turn (в течение 20 секунд)
Operate the electric ignition system (8): the flame should be 15 cm high
Open the valve (10) by 3/4 turns
Move away from the gas burner [1]
Открыть кран (6) до конца
The flame should be 3 - 4 m high
В случае неисправности работы: закрыть клапан (6)
Allow the gas to burn
When the flame intensity decreases, connect the tool [4] to the vehicle с помощью приспособления [5]
Send nitrogen to the LPG tank at a pressure of 4 bar
When the flame extinguishes, try to relight the burner several times, using the electric ignition system
When it is impossible to relight, allow nitrogen to escape through the gas burner for several minutes
Отключите
- Приспособление [3]
- Приспособление [5]
- The electrovalve (2) supply fly lead