Update no. 9 for the Peugeot on-board fault recorder (TEP 92), valid from 06-94 to 06-95 has the following two points
- Updating of the existing programs and processing new diagnostic programs
- Introduction of an interface unit (IPC 30) for the TEP 92 for communication with the centralised socket fitted initially on 806 and 605 (начиная с модельного года 95)
Новые программы диагностики
Управление электродвигателем (система SAGEM)
Контроль двигателя XU7JPL-Z (система BOSCH MP5.1)
Противобуксовочная система колес (система BOSCH ASR5)
Контроль двигателя XU5JPL-Z (система SAGEM LUCAS 4GJ)
Контроль двигателя XU10J4RL-Z (система BOSCH MP5.1.1)
Контроль двигателя XUD11BTEL3 (система LUCAS EPIC DC4P)
Контроль двигателя DK5ATEY (система BOSCH MSA11 3.6)
Контроль двигателя DK5ATEL3 (система BOSCH MSA11 7.6)
Подвеска с электронным управлением (система NIPPODENSO)
Суперблокировка (система KICKERT)
Кондиционер (система VALEO)
Проверка группы электровентилятора
Контроль двигателя XU10J2CL-Z (система MAGNETI-MARELLI 8P)
Контроль двигателя XU10J2CTEL-Z (система BOSCH MP3.2)
Антиблокировочная тормозная система (система BENDIX)
Климат-контроль (система BEHR)
Суперблокировка (система KICKERT)
Блок ремней безопасности
Проверка группы электровентилятора
New processes
Подвеска с электронным управлением (система NIPPODENSO)
Autodiagnostic test
Parallel test
Суперблокировка (система KICKERT)
Autodiagnostic test
Parallel test
Кислородный датчик (/)
Simplification of CS02 harness connections (сообщения, выводимые на экран)
Статическое зажигание
Detection of open and short circuit on plugs and plug leads on BOSCH injection-ignition systems все типы кроме 806 (ignition control interference during readings)
Центральный диагностический разъем
605 начиная с модельного года 95
806
Обработка
- Глобальный тест
- Тест по функциям
TEP 92/centralised socket adaptation
- 30 way centralised socket interface (IPC 30)
- TEP 92 interface /IPC 30 (PIP 08)
- IPC 30 / centralised socket interface (PCP 30)
Screen message improvements
Engine types sorted in alphabetical order
Screen display of cables to be used for ignition tests
Reminder, after erasing faults, to initialise injection control unit
Automatic selection of the target engine in the Tooth Signal Test
Automatic recognition in 405 engine type BFZ of SAGEM LUCAS 4GJ or MAGNETI-MARELLI 8P injection
Injection system parameter measurements
- Standardisation of parameters for all systems
- Units revised and standardised
- Parameters sorted in the same order of appearance for all systems
- Система впрыска
- Кондиционер 806
Composition of update no. 9
Product cassette no. 9
- 18 new diagnostic programmes
- 5 new processes
Документация
- New sheets обновления программного обеспечения
- Parameter Measurements and Injection System ECU Identification brochure
30 way centralised socket interface (IPC 30)
TEP 92 interface /IPC 30 (PIP 08)
IPC 30 / centralised socket interface (PCP 30)
2 адаптеров на 15 контактов для присоединения к двойному реле (используется реле BIP 722) - (available during October 1994)
1 oxygen sensor harness, (available during October 1994)
1 deadlocking-alarm harness, (available during October 1994)
Опция 1
- 1 605 95 MY air conditioning adaptor,(available during October 1994)
- 1 wiring adaptor (AC 92) - подвеска с электронным управлением (available during October 1994)
Опция 2: 1 wiring adaptor (AC 92) - суперблокировка (available during October 1994)