Метод ремонта
ПримечаниеThis operation consists in cutting the cable (1) linking the ECU to the multifunction switch and replacing it by a new cable (2)
Слить масло из коробки передач (см. соответствующую операцию)
Remove the ECU (см. соответствующую операцию)
Выход кабеля из своей защитной оболочки
Cut the cable (1) to the same length as the replacement cable (2)
Со стороны компьютера
- Cut the cable protection (1), taking care not to damage the wires (A = 40 mm approximately)
- Strip the wires along B = 15 mm
Engage the thermo-retractable sheath (3) (length 150 mm) over the cable (2) (on multifunction switch side)
Engage the sealed thermo-retractable connections (4) over each wire (on multifunction switch side)
Соединить провода, скрутив их концы, следя за тем, чтобы не перепутать цвета
Bring the connections (4) back onto the splices effected
Carry out the shrinking of connections (4) starting with the middle (melt the tin completely)
ВниманиеMake sure that no barb is piercing the connections (4)
Bring the thermo-retractable sheath (3) back over the links and carry out the shrinking operation
Put the cable back in its protection sheath
Refit the ECU (см. соответствующую операцию)
Залить в коробку передач масло и довести его до уровня (см. соответствующую операцию)