Снятие
Отвернуть болт (1)
ВниманиеNone of these operations should be forced
Removing the knob (2), для этого
- Lift up the knob (2) by approximately 10 mm
- Turn 1/4 turn rearward, lift up by approximately 7 mm
- Нажмите кнопку блокировки (3) и удерживайте ее в нажатом состоянии
- Turn 1/4 turn forward
Снять
- Рукоятку рычага переключения передач (2)
- Selection indicator (4)
Снять
- Болтов (5)
- Гайки (6)
- Центральная консоль (7)
Push aside the lower protection bellows (8)
Remove the upper protection bellows (9)
Отсоедините шаровую опору (10)
Снять
- Болт (11)
- Lever with locking rod
Установка
Grease the locking rod and lever articulation
Fit the locking rod
ВниманиеThe ends should be located in the apertures
Установите
- The lever provided with the 2 bearing shells and the spacer
- Болт (11)
ВниманиеCheck that the locking rod slides freely in the lever
Присоедините шаровой шарнир (10)
Установите
- The upper protection bellows (9)
- The lower protection bellows (8)
- Центральная консоль (7)
- Гайки (6)
- Болтов (5)
- Selection indicator (4)
ВниманиеNone of these operations should be forced
Refitting the knob (2), для этого
- Нажмите кнопку блокировки (3) и удерживайте ее в нажатом состоянии
- Fit the knob (2) to the lever until it butts (position the knob (2) as shown on the above illustration)
- Turn 1/4 turn rearward, move it down by approximately 7 mm
- Release the locking button (3)
- Turn 1/4 turn forward
Установить на место болты (1)
ВниманиеПроверить включение всех передач, if there is a problem, adjust the gearchange control (см. соответствующую операцию)