ВниманиеСоблюдайте меры предосторожности
Рекомендуемое оборудование
[1] детектор утечек FRAMET DF9
[2] gas burner
[3] gas burner adapter
[4] gas burner adapter
[5] станция для создания давления в пневматических блоках 4130-T
[6] пистолет
Partially drain the LPG supply circuit
Слив
Запустить двигатель
Перейти на работу в режиме агазб
Снять
- The tank cover
- Крышку (1)
Отсоединить электромагнитный клапан (2)
ВниманиеДождаться остановки двигателя после полной выработки сжиженного газа (gpl). выключить зажигание. отсоединить аккумуляторную батарею (positive terminal)
Operate the LPG supply circuit
Подсоедините обратно электромагнитный клапан (2)
Установите
- Крышку (1)
- The tank cover
Подсоедините обратно аккумуляторную батарею
Drain the LPG supply circuit
Слив
ВниманиеЧастично выпустите газ из системы питания сжиженным газом (см. соответствующую операцию)
Подсоедините обратно электромагнитный клапан (2)
Connect the LPG tank to earth
Disconnect the tube (4) from the union (5)
Connect the gas burner [2] to the vehicle using the connecting pipe (3) and the adapters [3] and [4]
Keep the valve (6) in the "off" position
ВниманиеPosition the gas burner [2] 20 m from any inflammable substances and as far away as possible from the vehicle
Connect the gas burner [2] to earth, в "a"
Open the valve (6) slightly
Connect the positive terminal of the electrovalve (2) to the positive terminal of the battery with a fly lead
Bleed the gas burner [2] by opening the valve (10) slightly until tube (9) ices up then close the valve (10)
Bleed the pilot tube by opening the valve (7) by 1/4 of a turn (в течение 20 секунд)
Operate the electric ignition system (8): the flame should be 15 cm high
Open the valve (10) by 3/4 turns
Move away from the gas burner [2]
Открыть кран (6) до конца
The flame should be 3 - 4 m high
В случае неисправности работы: закрыть клапан (6)
Allow the gas to burn
When the flame intensity decreases, connect the tool [5] to the vehicle с помощью приспособления [6]
Insert nitrogen into the tank at a pressure of 4 bar
When the flame extinguishes, try to relight the burner several times, using the electric ignition system
When it is impossible to relight, allow nitrogen to escape through the gas burner for several minutes
Отключите
- Приспособление [4]
- Приспособление [6]
- The electrovalve (2) supply fly lead
Connect the pipe (4) to the connector (5)
Подсоедините обратно аккумуляторную батарею
Operate the LPG supply circuit
ВниманиеPut 10 l of LPG in the tank. запустить двигатель. Перейти на работу в режиме агазб. check the seal of the connector (5) с помощью приспособления [1]
Fill up the tank to check the gauge valve works (ограничиться заполнением в 85%)