The development of a new bulkhead leads to a modification of the heater upper housing
Случай 1: replacement of a housing keeping the old heater
After removal of the fascia and the upper section of the heater: cut flush the marks (1) and (2) and file the mark (3)
Take new pipes (4): реферанс P.R 6464.X1
Fit two swivel fasteners (5) Part No. 6992.J3 to the corresponding pipes
Установить новые уплотнительные кольца: реферанс P.R 6467.40
Fit a seal to the engine compartment side of the bulkhead: реферанс P.R 6467.33
Установить на место приборную панель
Secure the swivel fastener to a fascia rib
Случай 2: replacement and adaptation of the upper housing
Cut flush the marks (1) and (2) and file the mark (3)
Реферанс P.R 6450.S1
Реферанс P.R 6450.S0
Реферанс P.R 6450.S2
Трубки: реферанс P.R 6464.X1
Уплотнительные кольца: реферанс P.R 6467.40
Уплотнительная прокладка: реферанс P.R 6467.33
Fit two swivel fasteners (5) Part No. 6992.J3 to the corresponding pipes
Нормативное время на проведение операции: 1,25 часов (fascia removal-refitting time not included)