Содержание Раздел: Электрооборудования
Все разделы

Device controlled by the cruise control ECU: описание различных элементов Peugeot 605 I

Компьютер (7310)

The ECU controls

  • The vacuum pump/breather solenoid valve assembly (7315)
  • The safety solenoid valve (7320)

According to the information received from the following components

  • Блок интерфейса (1625)
  • Коммутаторы (7305)
  • Концевой выключатель стоп-сигнала (2100)
  • Контакт системы безопасности круизконтроля (сцепление)
  • Предохранительное реле (7307) автоматическая коробка передач

On/off switch (7300)

This switch controls the switching on or switching off of the system

The integral indicator lamp is lit when switched On, it goes out when switched Off

Коммутаторы (7305)

Коммутатор имеет 3 нестабильных положений

Краткое нажатие вверх

  • Запоминание текущей скорости
  • Восстановление последнего запомненного значения скорости
  • Ускорение

Краткое нажатие в направлении к рулевому колесу: аннулирование запомненной скорости

Краткое нажатие вниз

  • Запоминание текущей скорости
  • Торможение

Датчик скорости автомобиля (1620)

Impulse generator type of sensor

This sensor delivers a sine-wave signal whose frequency is proportional to vehicle speed

For this type of sensor, a vehicle speed interface unit is always fitted

Блок интерфейса датчика скорости автомобиля (1625)

This unit converts the sine-wave signal from the vehicle speed sensor into a square wave signal which can be used by the control unit

Cruise control vacuum pump-breather solenoid valve (7315) assembly

The vacuum pump controls, by depression, the vacuum capsule connected by a cable to the throttle butterfly

The breather solenoid valve can connect the vacuum circuit to atmosphere

Предохранительный электромагнитный клапан (7320)

The solenoid valve rapidly opens the vacuum capsule to atmosphere, causing the vehicle to decelerate

This solenoid valve is open when there is no supply to it

Пневмоклапан

The vacuum capsule acts on the throttle butterfly according to instructions from the vacuum pump/breather solenoid valve assembly (7315) or the safety solenoid valve (7320)

  • Increase in vacuum causes the throttle butterfly to open (action of the vacuum pump)
  • Reduction in vacuum causes the throttle butterfly to close (action of the breather solenoid valve or the safety solenoid valve)

Концевой выключатель стоп-сигнала (2100)

This switch is open in the rest position

Он информирует компьютер (7310) об отпущенном положении тормозной педали

Контакт системы безопасности круизконтроля (тормоза) (7308)

Этот концевой выключатель замкнут в положении отпущенной педали

Он информирует компьютер (7310) об отпущенном положении тормозной педали

Контакт системы безопасности круизконтроля (сцепление) (7306)

Этот концевой выключатель замкнут в положении отпущенной педали

It informs the control unit (7310) of the rest position of the clutch pedal

Предохранительное реле (7307)

This relay informs the control unit (7310) of the gear lever position: N или 1,2,3,D