Identification of bonnets
Steel bonnet
- Крепление с помощью 4 гаек: M8 x 125
- Амортизаторы: body fitted at the bottom
Капот из алюминиевого сплава
- Крепление с помощью гаек: M8 x 125
- Амортизаторы: body fitted at the top
ВниманиеThe calibration of the struts differs depending on whether the bonnet is made from aluminium or steel; therefore, the struts are not compatible
Steel bonnet
Капот из алюминиевого сплава
ПримечаниеThe thickness of the inner panel at the clipping point changes from 0,8 mm for a steel bonnet to 1,2 mm for an aluminium bonnet: the jets are therefore specific
Replacing an aluminium bonnet
Order from Parts Division
- 1 steel bonnet
- 2 амортизаторы
- 2 жиклеры стеклоомывателя
Заменить в сборе
Replacement of a strut or a jet
Following damage to a strut (leak or other incident) or a windscreen washer jet
Свяжитесь с вашим региональным техническим консультантом (для Франции) и со службой послепродажной технической помощи в вашей стране (для стран экспорта)
Покрытие антикоррозионным составом
Панель: as aluminium is a soft material, it is advisable to replace the bonnet (only minor repairs are permitted)
Окраска
Component scratched down to the metal surface
ВниманиеReconstruction of the original base coat on the stripped metal surface, apply an etch primer in order to ensure correct adhesion of the products
Sanding must be carried out using P500, as a general rule, it is advisable to use a finer grain size (a grade lower) to avoid deep scratches which are difficult to conceal