Снятие
Снять
- Облицовку крыши
- Люк
- Подвижная панель
ПримечаниеIt is recommended that the guide blocks are changed one side at a time
Снять
- The handle unit (1)
- The cable-operated mechanism (2)
- The moving arms (3) (спереди)
Снять
- Резиновый упор (4)
- Салазка (5)
Replace the guide pads (6)
Установка
Engage the carriage (5) in the runner (7) and the cable (8) respectively, by means of guides "a" and "b"
Refit the rubber stop (4)
Engage the moving arm (3) (спереди)
Проделать аналогичную операцию с другой стороны
ВниманиеBefore continuing with the refitting, check that the guides of the carriages and the moving arms are located correctly in the runners
Refit the cable-operated mechanism (2) in its frame and pre-tighten the fixings (9)
Place the carriages (5) in the fully open position, against the rear stops
Refit the handle unit (1)
ВниманиеAfter refitting the handle unit (1), check that the carriages (5) are properly against their stops
Tighten all of the fixings (9) as well as the fixings of the handle unit (1)
Place the cable-operated mechanism (2) in the closed position
ВниманиеCheck that the moving arms (3) are still properly located in their runners
Refit the sliding panel
Pre-tighten the sliding panel fixings
Clean the contact surface of the sunroof on the roof
Проверить состояние следующих элементов
- Прокладки (10)
- Sound-deadening foam pads (11)
Установить на место вентиляционный люк
Check that it is properly centred by means of the pins "c" and the positioning of the clip (12)
Предварительно затянуть крепления (13) (выполняйте указанную последовательность)
Затянуть крепление (13) с моментом 0,5 дНм
Установка производится выполнением операций по снятию в обратном порядке