Содержание Электросхемы Раздел: Контрольно-измерительные приборы, контрольные лампы (индикаторы) Все разделы

MIL lamp on for approx. 4 secs. after engine start (VDO instruments only) Opel Astra G

Engine - MIL telltale lamp flashes for about 4 seconds

Models:

Astra-G 2001

Engines:

1.7D

Option:

Y17DT, VDO Instruments

Group:

N - Electrical Equipment

Troublecode:

Non

Complaint:

Electrical failures

After engine start the MIL telltale lamp flashes for about 4 seconds (only VDO instruments).

Cause:

Wrong pin assignment at wiring harness connector of instrument wiring harness. Pins for SVS and MIL telltale lamp are interchanged.

Production Solution:

As of the following VINs an improved wiring harness is used in production:

Antwerpen: 15041639, Bochum: 12024364, Ellesmere Port: 18007696

and Eisenach: 16010939.

Remedy:

Special Part:

Kein

Remove instrument assembly and change pin assignment at wiring harness connector instrument wiring harness (change pin assignment 29 and 34) .

Working Procedure:

1. Remove instrument assembly.

- see working procedure "Instrument Assembly, Remove and Install or Replace", unit "N", Service-Instruction Astra-G.

2. Remove wiring harness connector instrument wiring harness with bracket from instrument panel.

3. Disconnect wiring harness connector instrument wiring harness from bracket.

4. Remove secondary interlock from wiring harness connector (pic. I, arrow) .
.P. _1362F01.tif97,5tiff;;

5. Unlock pin assignment 29 and 34 (pic. II) with MKM-923-12-A. Change positions and lock.

Caution:

Take care for correct fitting of the pins in the wiring harness connector!
.P. _1362F02.tif97,5tiff;;

6. Install secondary interlock to wiring harness connector.

7. Clip wiring harness connector instrument wiring harness to bracket.

8. Install bracket with wiring harness connector instrument wiring harness in instrument panel.

9. Install instrument assembly

- see working procedure "Instrument Assembly, Remove and Install or Replace", unit "N", Service-Instruction Astra-G.

Labour times: TC: Hours:

T 8 136 20 Change pin assignment wiring harness 92 0.5

connector instrument wiring harness

The regular warranty procedure should be used for claiming set-up-time.